24V DC
Error
Via LED
Automatic
Activation
The phenomenon of a hydraulic lift not accurately approaching the stop is observed in the vast majority. As a result, the cabin about the floor forms a "staircase" and the passage becomes problematic. The need for releveling is therefore imperative and is not a luxury but a substantial intervention in the operation of the elevator.
To cover such a function, movement is needed, while for safety reasons it is necessary to be sure that the cabin is behind the floor. So we can talk about a zone +/-10cm from the floor. This condition is served by amorgos through two sensors that must be activated while the cabin is in range. Amorgos enables 2 forced guided relay contacts to allow movement. At the same time, it monitors the correction is made within the zone, so if it goes outside stops immediately.
More about Relay Contacts •Amorgos is housed in a 3 DIN rail box allowing easy installation and application to the panel by having plug-in terminals and markings showing their function. The product is certified for its specific use while counting almost two decades of the successful and resulting function.
More about Modulbox • More about Plug-in Terminals •- DIN rail
- 3
- Error indications via LED
- Yes
- Automatic start
- Yes
- Power supply
- 24V DC
- 2 forced guided relay contacts
- Yes
- Consumption
- <5W
- Check both inputs before arming the Safety Relay
- Yes
- IP protection
- Terminal: IP20
Housing: IP40
- Operating temperature
- -20° C ~ 60° C
- Dimensions
- 49 x 49 x 110 mm
- CE certification
- Yes
